Page 2 of 2
Posted: 2007-03-10 22:22
by mavit
{9thInf}GunnyMeyer wrote:Yeah, for a real assault the military either puts a board over it or as I have heard of the VC doing in Vietnam from my dad they would just have one guy run and jump on top of it to squash it down...
The British still do.....one guy leaps on the top...the other either climb up his back or run and jump over......last man grabs hios belt buckle and throws him over like a roley poley
Posted: 2007-03-10 23:19
by Mongolian_dude
It would not be too hard to do i think.
Maybe something along the lines of...:
Razor wire would have to count as a tactical asset, like a bridge. By this, i mean you can destroy it and repair it. Perhaps the wire cutters could be basicly an anti wrench that deducts from integrity, instead of repair it. The problem would be that it would work on bridges too but you could make the rate of deduction so neglegable it would take about half an hour to destroy the bridge that way. Also, the amount of DMG razor wire would have to take would be quite low (i would think it that way RL too)
...mongol...
Posted: 2007-03-10 23:25
by NavalLord
'[R-MOD wrote:Mongolian_dude']It would not be too hard to do i think.
Maybe something along the lines of...:
Razor wire would have to count as a tactical asset, like a bridge. By this, i mean you can destroy it and repair it. Perhaps the wire cutters could be basicly an anti wrench that deducts from integrity, instead of repair it. The problem would be that it would work on bridges too but you could make the rate of deduction so neglegable it would take about half an hour to destroy the bridge that way. Also, the amount of DMG razor wire would have to take would be quite low (i would think it that way RL too)
...mongol...
If it was low then grenades could destroy it.
Posted: 2007-03-11 10:27
by AfterDune
But grenades
can destroy barbed wire. I mean, I've seen the stuff get blown up after a grenade exploded there (or... was it a rocket? either way, it's destroyable
)
Posted: 2007-03-11 18:00
by A-10Warthog
no they cant, their a high tensil (spelled right?) strength steel and right now only wire cutters can cut through and its still VERY hard