Page 3 of 3
Re: Custom PR map crash at 100%
Posted: 2018-09-03 15:14
by dunem666
Thanks, I have tried this but the debug mode won't work. It always forces into fullscreen and the only way to exit is by opening a second desktop, dragging task manager into it to then close it.
Re: Custom PR map crash at 100%
Posted: 2018-09-08 13:35
by dunem666
Not even debug is helping overcome my map crashing at 100% loading. Iv'e lost a week of working on my map now to this problem.
Re: Custom PR map crash at 100%
Posted: 2018-09-08 13:41
by Mineral
have you gone over the init.con and stopped loading individual items? Stop loading statics, stop loading terrain, stop loading water, stop loading ambient, etc etc. Just remove lines from the init.con file until you can narrow it down.
Re: Custom PR map crash at 100%
Posted: 2018-09-08 14:00
by dunem666
Mineral wrote:have you gone over the init.con and stopped loading individual items? Stop loading statics, stop loading terrain, stop loading water, stop loading ambient, etc etc. Just remove lines from the init.con file until you can narrow it down.
Thanks for this, I will try this out now.
Re: Custom PR map crash at 100%
Posted: 2018-09-08 16:21
by dunem666
I have made a new map in BF2editor, single handed moved accross each file one by one into the new map to try and pin point the fault.
The map loads and I have copied nearly everything. Now the problem is, even once I have copied everything over the terrain is not the same.
I give up. I just don't know what I am supposed to do anymore to try and find this fault.
Over 200 hours of work has gone into this map so far, there MUST be a better way to diagnose a map crash CTD at 100%...
Re: Custom PR map crash at 100%
Posted: 2018-09-08 17:19
by Outlawz7
Can you send it over, I'll take a look.
Re: Custom PR map crash at 100%
Posted: 2018-09-11 19:45
by dunem666
Outlawz7 wrote:Can you send it over, I'll take a look.
Thank you very much for the offer but I have fixed the issue.
I made a new map, and copied content over 1 by one / file by file until i found the fault....
Couldn't find it, never the less the map is loading as expected.
I am convinced it was something to do with lightmaps.tai but not 100% sure.
Re: Custom PR map crash at 100%
Posted: 2018-09-12 04:07
by ALADE3N
dunem666 wrote:Thank you very much for the offer but I have fixed the issue.
I made a new map, and copied content over 1 by one / file by file until i found the fault....
Couldn't find it, never the less the map is loading as expected.
I am convinced it was something to do with lightmaps.tai but not 100% sure.
If it has to do with the lightmaps.tai , it will pop up if you have run the game in window mode