Page 1 of 2

Ati 6950 problem

Posted: 2011-08-11 17:05
by Mesterson
I bought new powercolor 6950 hd and everything is going smooth on othet games except pr.
I have about 20 to 60 fps on pr and I don't have any idea what would cause this. My gpu load usually is about 60% to 99% when Im playing but on pr only 1% to 40%
My system is amd phenom 955BE @3.4ghz, 4x2gb 1333mhz ddr3, powercolor 6950, and 600w corsair.

Re: Ati 6950 problem

Posted: 2011-08-11 17:39
by samogon100500
Mesterson wrote:I bought new powercolor 6950 hd and everything is going smooth on othet games except pr.
I have about 20 to 60 fps on pr and I don't have any idea what would cause this. My gpu load usually is about 60% to 99% when Im playing but on pr only 1% to 40%
My system is amd phenom 955BE @3.4ghz, 4x2gb 1333mhz ddr3, powercolor 6950, and 600w corsair.
All,what needs to PR - RAM and CPU,Videocard - just adapter for your monitor here :razz: .
I uses Phenom X4 925 and GeForce 8600 GTS also have stable 50 fps on mostly maps on High but without AA.Also I will buy Sapphire R6950 tomorrow :-P .

Re: Ati 6950 problem

Posted: 2011-08-11 18:39
by Cossack
Yeah, it looks that CPU is too weak.

Re: Ati 6950 problem

Posted: 2011-08-11 22:06
by BloodBane611
Cossack112 wrote:Yeah, it looks that CPU is too weak.
A 955 BE is too weak? I have a 945 and I play PR maxed out just fine.

I can't say what the problem is, but that doesn't match up with reality.

Re: Ati 6950 problem

Posted: 2011-08-12 05:59
by Mesterson
Before 6950 I had 5770 hd and had average of 90 fps on all maps. I run blac ops and bad company 2 with all settings on highest with 90 fps

Re: Ati 6950 problem

Posted: 2011-08-12 07:39
by Psyrus
I assume you've loaded the latest catalyst drivers to make sure it's not that (although since you say other games work, I guess it wouldn't be that)?

Also my brother had a HD5770 and he definitely didn't get an average of 90fps on all maps, even @ 1280x1024 (before I bought him his 24"WS), I call furphy on that one.

Re: Ati 6950 problem

Posted: 2011-08-12 09:37
by Mesterson
I think all I can do is wait for better drivers. I have tried 3 different drivers and they all have been the same.

Re: Ati 6950 problem

Posted: 2011-08-12 10:21
by Psyrus
Mesterson wrote:I think all I can do is wait for better drivers. I have tried 3 different drivers and they all have been the same.
Well if it's not the drivers, can you run a couple of benchmarks just to make sure everything is 100% right (outside of PR)?

Once you've confirmed the hardware side is all sweet then you just have to start messing with PR stuff.

Re: Ati 6950 problem

Posted: 2011-08-12 10:47
by Mesterson
I just ran 3Dmark vantage with performanse preset and results are: score P15766
GPU 18272
CPU 11171

Re: Ati 6950 problem

Posted: 2011-08-12 12:57
by Psyrus
Mesterson wrote:I just ran 3Dmark vantage with performanse preset and results are: score P15766
GPU 18272
CPU 11171
That's pretty much bang on the money for your GPU, it's not being bottlenecked by your CPU (see these reviews (1 | 2) with a higher spec processor)

Firstly, I don't have any idea if this will have a performance impact but whenever I got a new graphics card (several times over bf2/PR), I would always clear the shader cache and have it rebuilt.

Also, use catalyst AA or set your ingame AA to 8x - I performance tested and 2x, 4x AA (ingame setting) both gave me worse performance than ingame 8x. :confused: :confused:

Do you have fraps? If you do, could you run the benchmark mode on a map like fallujah + one like ramiel/kashan and post the average, min & max of your drive arounds?

Re: Ati 6950 problem

Posted: 2011-08-12 14:29
by Mesterson
Well I also deleted all cache and even reinstalled whole game and bf2. I do have fraps and I'l look in to it tomorrow when I have more time.

Re: Ati 6950 problem

Posted: 2011-08-18 14:04
by Mesterson
Today I had fraps on while playing fallujah and my average fps was 29.89, max was 152 and mininum 0.

Older results on some other maps, which were barracuda and I don't remember the other one.
min 0, max 91, average 25.84.

min 0, max 551, average 77.97

Re: Ati 6950 problem

Posted: 2011-08-18 14:22
by Cossack
Its fine results. I had pretty much everything the same with E8200 @ 2.66 GHz, 4 GB of RAM DDR 2 @ 800 MHz and 9600GT, resolution - 1680x1050, everything maxed out.

Re: Ati 6950 problem

Posted: 2011-08-18 16:52
by Mesterson
But I had like three times more fps with my old 5770 and this videocard is like two times better. I just dont get it...

Re: Ati 6950 problem

Posted: 2011-08-18 17:32
by Cossack
maybe driver bug? Its hard to tell. But about other games? same thing?

If its just PR, then its very specific case.

Re: Ati 6950 problem

Posted: 2011-08-18 17:34
by Mesterson
Only pr, even arma II runs with all max for about 40 fps and below

Re: Ati 6950 problem

Posted: 2011-08-18 17:41
by samogon100500
Mesterson wrote:But I had like three times more fps with my old 5770 and this videocard is like two times better. I just dont get it...
Well,as I says I buy this card.FPS almost same(Sometimes a little higher) as on my old 8600GTS on all high w/o AA.

Re: Ati 6950 problem

Posted: 2011-08-18 18:13
by Cossack
I have no clue, why its not performing better as it should be... This is real mystery for me. :roll: :( Maybe driver bug or something else. While its PR only, then your GPU simply don't like PR. :D

Re: Ati 6950 problem

Posted: 2011-08-18 18:23
by Mesterson
Well then I dont like my gpu... Today I was playing Bashar skirmish and had mininum fps 70, average about 100 and max 140. But thats only map which works as it should be.

Re: Ati 6950 problem

Posted: 2011-08-23 17:28
by Mesterson
With new pach I now get average fps of 60 on maps with a lot of objects and maps like Kashan 90-130 average. So everything is as it should be now. Thanks all for helping.