Project Reality Forums

In PR settings i noticed that there most of them HIGH or LOW .

in this website :
TweakGuides.com - Battlefield 2 Tweak Guide

Geometry Settings :
More importantly, at the higher levels vehicles will come into view sooner when far away, as more of their details are shown earlier.

Question is : If i play with Geomery Settings on LOW will i have disadvancing because enemy armor will come into view range later ?


*I trying to Crank my FPS to max
and i noticed that geometry is HIGH vs LOW its about 7 fps .

What I did on my older machine was turn texture rendering to low and draw distance to high (100%). A worthy trade off.

Wing Walker wrote:Just fire up an offline map and turn all settings down to low, and slowly increase 1 at a time, and load the map after each time, and test it out.

It takes a while but it works.

Sometimes FPS drops are caused by a bunch of players on the map so configuring based on offline performance isn't 100% accurate.

As long as you have view distance on 100% you will see armor normally.