Page 1 of 1

French VBCI Gun alignment

Posted: 2017-03-08 08:23
by FFG
Description:
It seems both the main gun and the coax are not aligned with the crosshair. (Probably a feature)

Steps to Reproduce:
I noticed this on Marlin cq std

Screenshots / Video:
Image
The yellow line is where the cannon seems to deviate around, where the redline is where the coax seems to fire towards

Tested On:
marlin cq std

Video Settings (if needed):
all low, 1920x1080

Re: French VBCI Gun alignment

Posted: 2017-03-09 18:54
by Mats391
It is 100% centered. You are wrong.

Re: French VBCI Gun alignment

Posted: 2017-03-09 19:34
by tankninja1
I don't think the coax for any vehicle aligns with the main aiming reticule.

Re: French VBCI Gun alignment

Posted: 2017-03-09 22:45
by FFG
'[R-DEV wrote:Mats391;2159272']It is 100% centered. You are wrong.
Must just be because the gun is on the right side of the camera, but the rounds fire from the left.....

Re: French VBCI Gun alignment

Posted: 2017-03-10 01:25
by QuickLoad
tankninja1 wrote:I don't think the coax for any vehicle aligns with the main aiming reticule.
well at first - no. because coaxil is not inside of the main barrel nor inside of the camera, same how the main gun isn't inside of the camera.
though: wherever the weapon is zero'd will be where the coaxil hits the center of the crosshair, so say if the APC is deisgned to hit infantry targets at 100m, the coaxil will be facing slightly to the left(or right in some cases) until it can hit targets at 100m dead center.