Project Reality Forums

I've been trying to get started on my Fulda Gap map but I can't get past the exportation phase with the L3DT program (2.5c Standard). Since I've decided to make my map 2x2km, I should export the file at 2049x2049 (the tutorial said to add a pixel, so I'm not going to argue) however the maximum resolution I can export is 2048x2048, a poetically cruel number.

Do any of you have any suggestions as to work around this?

export it then in photoshop add the extra pixels...

you dont have to export it with 2049 neither 2048. Export with 1025x1025...the heightscale is not of interest in this case
at least for me ...?!

[R-CON]marcoelnk wrote:you dont have to export it with 2049 neither 2048. Export with 1025x1025...the heightscale is not of interest in this case
at least for me ...?!

that is correct in fact, just checked and it is 1025x125 for a 1024x2 map (2km x 2km)

but again, it will probaly only let you export at 1024 then just add the extra pixel with photoshop.

[R-DEV]Rhino wrote:that is correct in fact, just checked and it is 1025x125 for a 1024x2 map (2km x 2km)

but again, it will probaly only let you export at 1024 then just add the extra pixel with photoshop.

no, 2.5c standard will let you export with 1025

Alright thanks guys!