Page 1 of 1

Saitek x52, how do i assign a button to say: "Affirmative a vehicle is on the way."

Posted: 2009-04-12 15:50
by Regan
Can someone tell me what the keyboard commands are to say this: “Affirmative a vehicle is on the way.” I want to set this as a button press on my saitek x52 thrust controller, but don’t know the keyboard commands. Thanks!!

Re: Saitek x52, how do i assign a button to say: "Affirmative a vehicle is on the way

Posted: 2009-04-12 16:48
by AgentJadeD
just assign a button for page up is the closest youll probably get to that.

Re: Saitek x52, how do i assign a button to say: "Affirmative a vehicle is on the way

Posted: 2009-04-12 16:59
by Rhino
ye, its a hard one as there isn't a button assigned to that command afaik... you could assign a button to Q or T or w/e it is, then use the mouse on youre throttle to go to the right one but ye, I know that mouse is really hard to use, espically while flying :p

Re: Saitek x52, how do i assign a button to say: "Affirmative a vehicle is on the way

Posted: 2009-04-12 18:31
by Regan
I was sure that somewhere in these forums there was a profile that allowed you to do this. Someone uploaded one for the saitek x52, but I just cannot find it now. Does anyone know where it is? Thanks again!!

Re: Saitek x52, how do i assign a button to say: "Affirmative a vehicle is on the way

Posted: 2009-04-12 18:34
by Rhino
your probably thinking of a "Roger That" that AgentJadeD was referring too which you can simply the "Page Up" button, and also "Page Down" is "Negative", I put them on the HAT switch of my throttle so that page down is yes (Page up) and pulling it back up is "no" (page down).

Make any seance? :)

Re: Saitek x52, how do i assign a button to say: "Affirmative a vehicle is on the way

Posted: 2009-04-13 07:41
by Regan
[R-DEV]Rhino wrote:your probably thinking of a "Roger That" that AgentJadeD was referring too which you can simply the "Page Up" button, and also "Page Down" is "Negative", I put them on the HAT switch of my throttle so that page down is yes (Page up) and pulling it back up is "no" (page down).

Make any seance? :)
Ok thanks guys and yes it makes sense, but I have the hat switch on my throttle set as rudder, it's brilliant to aim with in the little bird when it's set like this. I have just ordered myself some rudder pedals, so fingers crossed that they are a good buy. Do you use rudder pedals and if so how do you find them?

Re: Saitek x52, how do i assign a button to say: "Affirmative a vehicle is on the way

Posted: 2009-04-13 08:05
by Rhino
na aint got them, they where really expensive last time I looked. Was tempted in getting them for vehicles too, using them as a throttle pedals :)