Page 1 of 1
Jabal Al burj carrier shield
Posted: 2009-08-23 21:29
by DEADLY_sniper
Hello all.
I dont know if I am posting into the right forum but anyway.
Recently we had a CW on Jabal Al Burj. We started as MEC and our plan was to hold west beach until other flags are captured. After we captured Dam enemy apc appeared in the water. We shot it with everything but as I heard it was behind some sort of carrier force field. it scored about 50 kills and eventually we lost.
But when we played as USA, we were quite winning. I had 22:4 score with my machine gun

, attack helis spawned, took off etc. When both went back to reload rockets, they were destroyed by enemy. So was every vehicle on carrier. Shouldnt they be protected by force field too? Or how it works?
Thank you for replies.
Re: Jabal Al burj carrier shield
Posted: 2009-08-23 21:42
by Spec
You're probably talking about the death-zone for enemies around it. Only gives you the "get back to your position" message and eventually kills you if you don't leave. But doesn't stop bullets.
Re: Jabal Al burj carrier shield
Posted: 2009-08-23 22:02
by Vitiation
I belive they put some kind of sphere around the carriers in PR to prevent AAs being fired towards them...
I know they have it on baracuda
Re: Jabal Al burj carrier shield
Posted: 2009-08-23 22:10
by DEADLY_sniper
Spec_Operator wrote:You're probably talking about the death-zone for enemies around it. Only gives you the "get back to your position" message and eventually kills you if you don't leave. But doesn't stop bullets.
I am most certain there is a force field around carrier which protects units inside and it is same big as the death -zone. We shot the apc multiple times with HATs LATs and our apcs, besides the guy who told me hardly would just make it up.
Re: Jabal Al burj carrier shield
Posted: 2009-08-23 22:13
by Spec
Hmm... Maybe they did, didn't know that.
Re: Jabal Al burj carrier shield
Posted: 2009-08-23 22:19
by Outlawz7
The carrier protection mesh has a 500m radius, which kinda reaches the beaches on Jabal, since the carrier is so close to land.
Re: Jabal Al burj carrier shield
Posted: 2009-08-23 22:30
by Rhino
ye it probably needs to be removed from Jabal or made much smaller.
Re: Jabal Al burj carrier shield
Posted: 2009-08-23 22:38
by DEADLY_sniper
and those destroyed vehicles on carrier?
Re: Jabal Al burj carrier shield
Posted: 2009-08-23 22:50
by CAS_117
@Rhino: just lower it or move it south. Both reduce the distance from the shore.
Re: Jabal Al burj carrier shield
Posted: 2009-08-23 23:01
by FuzzySquirrel
Yea you've got like 2 Grids south of the carrier, MOVE ET!
Re: Jabal Al burj carrier shield
Posted: 2009-08-23 23:29
by DEADLY_sniper
ok we found out..

[BOS] UNIKALUS [BOS] VALDAS were crewmen in both APCs. I hope I wont see such pros again
Re: Jabal Al burj carrier shield
Posted: 2009-08-29 09:59
by Outlawz7
The shield only protects the carrier from projectiles coming in from outside of it, not inside and I think that spot was reported before, also the beach isn't inside the dome of death (the 'going out of bounds' thing) so you can still get close enough.
Re: Jabal Al burj carrier shield
Posted: 2009-08-29 15:41
by Le_Damner
Yeah, some part of the beach here must be on dome of death, you can go there with the AA and take down choppers directly on the deck.
Re: Jabal Al burj carrier shield
Posted: 2010-01-17 17:22
by 2ClipsOneKill
Does this explain why we, as USMC (me with a SAW) standing on a hill south of the Dam couldn't hit a single MEC guy in a squad running on the shoreline around where the dome of death starts? I expended a magazine, and all of our squad was shooting away without a single flinch from our targets for reaction.
I swear that I saw around 5 tracers from the SAW (=alot of bullets) "hit" a guy laying down shooting at us but he didn't even twitch.
Either this or some odd network quirk I've never seen.
They moved ~ 200m west though and then I could mow them down without any problem.
Re: Jabal Al burj carrier shield
Posted: 2010-01-28 05:30
by Startrekern
Confirming this bug. Two hydra hueys got wiped on the deck by some baserapers on TG, with the MEC AAV.
Re: Jabal Al burj carrier shield
Posted: 2010-02-04 15:30
by Sniperdog
Bear in mind, when its on the carrier the dome is a part of one of the carrier pieces by default so you cant really lower it as it stands. I think the dome colmesh should be removed from the carrier model and always be placed by the mapper so he can configure it to the appropriate map. Having Domes at varying sizes would be nice also...