No signal to monitor
Posted: 2010-03-13 09:58
So I have been helping a friend replace his motherboard and processor with a K9A Platinum and Athlon 5000+X2. Having installed all the components correctly (or at least with no obvious errors) and the computer starting up seemingly fine (lights on, fans spinning, etc.) we get the very annoying problem of the monitor just not getting a signal.
We have tried using a different monitor, with the same result. My guess is that the GPU may be knackered, but it does appear to start OK, with the fan spinning and whatnot. Otherwise it could be the motherboard, but as I said all the other components on it seem to check out. I've tried resetting the CMOS but I might try to do it again because I'm not sure I did it properly last time. I've tried taking the card out and putting it back, cleaning the contacts and all the basic precautions with no luck.
Basically I'm all out of ideas, any help on what to try next would be hugely appreciated!
We have tried using a different monitor, with the same result. My guess is that the GPU may be knackered, but it does appear to start OK, with the fan spinning and whatnot. Otherwise it could be the motherboard, but as I said all the other components on it seem to check out. I've tried resetting the CMOS but I might try to do it again because I'm not sure I did it properly last time. I've tried taking the card out and putting it back, cleaning the contacts and all the basic precautions with no luck.
Basically I'm all out of ideas, any help on what to try next would be hugely appreciated!