Project Reality Forums

I wounder if the R-Dev could take the time to fix that damn thing, ( dont miss understand me i'm not bitchin its just anoying ). In P.R. you see on the left side of the barrel ( of praticly any armed vehicle ), thats the right position for APC like the LAV25, LAV3, since the gunner optic are on the upper left side of the gun, but in the tank, the optic are on the upper RIGHT side of the tank. Not on the left. I'm pretty sure that it wont take "that long" to fix since its pretty much a minor issue, but it will add realism and you wont have the canon blockin a such big part of you're LOS.

Probably somebody already complained about this but when we zoom the driver's escope the sensitivity gets too high and it is hard to smoothly look at something at distance. Any minor touch to the mouse is like a hasty moviment while not zoomed in.

i'm talking about the aiming optic, not the C.C. periscope.

It would be more realistic. But it'll probably be a low priority on the Dev's lists.

the Challenger 2's gun sight has moved a couple of times afaik due to new info on realism, hotrod, you got and references?

[R-CON]Rudd wrote:the Challenger 2's gun sight has moved a couple of times afaik due to new info on realism, hotrod, you got and references?

Honestly we dont need any classified info to know it just look at the picture So basicly its like if the optic was looking trought the armor, same would apply for MARKEVA, LEOPARD2, the only tank i dont know where the aiming optic are is the T-series... Might be a low priority but it will add realism =)

thanx for the info, but still, it prove that im right, the optic are higher than the barrel even on T-series

the problem is that the coaxial mg should be off the sight.

so if the coaxial mg is on the right side of the barrel than the camera needs to be on the left side.

so some have it on the "right" spot while other have it on the "wrong" spot for gameplay sake.