Zeudon wrote:I do not have a separate graphic card, but i have 1 in my motherboard.
Will Project reality mod lag ALOT if i play in lowest quality and resolution?
I have:
Windows XP
Processor: Intel Pentium 4
Memory: 512 MB DDR SDRAM
Graphic card(In my motherboard): ATI Radeon Xpress 2000
Hard drive: 160 GB
Monitor: Princeton '17
I really want PR mod since it looks so good.
Thanks for the help!
-Zeudon564
How is your performance in regular vanilla BF2 mate? If you are running slow in your opinion in regular BF2, i wouldn't expect good performance in PR at all.
Type renderer.drawfps 1 in the console while in-game to find-out.
Unscientifically do you feel BF2 runs slow on medium settings.
In my opinion you should bring your system up to the level where you can run the game on Medium detail to really see the best of PR.
also to answer your question about the gfx card....
Which of the following are you running? (check your ATI control panel to find out)
HD 2900 XT (top end)
HD 2600 Pro
HD 2600 XT
2400 Pro
2400 XT (low end)
(those seem like the most likely ones).
- Mhz of your processor?
- You will need lots of memory (2GB is recommended with an on-board card)
- Try some of the well known XP tweaks too.
Overall, i would make sure your drivers are up to date, you have used some of the recommendations of the BF2 tweakguides (use with caution).
Borrow some memory (2gb) if you can or buy some 2nd hand, as you don't want to waste your money on a system that may need the upgrade.
Good luck, and report back on these points, and we might be able to help a bit more.
For an experiment i did get PR working ok on a Duron 1800 once with a 7600GS card and 1.5gb of ram, with a LOT of tweaking and overlclocks (just to show it can be done) so best of luck, especially if you are trying for experimental reasons.