Respawn time 6000 seconds?

[zvenner]

Hey,

I've tried to play the new PR version and it seems to be very great.

But somehow, I can't respawn. I'm in a sqaud, I've started PR-Mumble as administrator before I launch Project Reality and I don't have any limited kit selected.
Plus I killed myself, so I can't be revived.

What changed?!

[Pvt.LHeureux]

Instead of pressing enter to spawn you must click "Done" in the bottom right of the map on the spawn screen. It was implemented to avoid accidental respawns, it works well

[Cossack]

Don't just press Enter, but with mouse click "Done". You should be fine now.

[Stemplus]

remember, if you select a spawn point and click done, then if you want to change your spawn point you need to select it and click done again

[a3dboy1]

Never had problem with spawning in PR 0.97...I bet, it is vanilla's influence

[ghostfool84]

A Kitchange in the spawnscreen can help too, sometimes its just messed up even when a valid spawnpoint is selected.

[MrTomRobs]

Sometimes there are issues with spawning, a couple of times i've been unable to spawn even when a rifleman kit is selected no matter where i try to! The issue only gets fixed when i choose a different kit! Strange, but it works!

But usually it's because you need to consciously click your spawn point and then 'Done'.

[ComradeHX]

Hey,

I've tried to play the new PR version and it seems to be very great.

But somehow, I can't respawn. I'm in a sqaud, I've started PR-Mumble as administrator before I launch Project Reality and I don't have any limited kit selected.
Plus I killed myself, so I can't be revived.

What changed?!

You must read the manual to be able to spawn in less than 6000 seconds.

[Spec]

Closing this as the question has been answered. If anything isn't clear, or if it didn't work, PM me or start a thread in the bug section, zvenner, although I hope everything already works now.