Is it possible?

SethLive! · Post by **SethLive!** » 2007-09-23 20:13

is it possible to remake (redraw?) the 2d sights used for all the guns? I know it would be alot of work but some sights (especially ak47, sks, and pkm) really need to be redone.

some of the sights are perfect as they are (sa80) and some are going to replaced in the near future anyway (m16).

But I am just wondering if this is as easy as it sounds, cause drawing a 2d sight would seem much easier than making a 3d model.

I'm not demanding anything or complaining, but i do think this would be a worthwhile way for the pr team to use their valuable time.

Xander[nl] · Post by **Xander[nl]** » 2007-09-23 20:39

That would require new models for every weapon you'd like to change. Since DICE models cant be edited. (I think)

And that takes a very lot of time.

Post by **Vaiski** » 2007-09-23 21:51

Yes its possible.

Expendable Grunt · Post by **Expendable Grunt** » 2007-09-23 22:35

Doesn't the Ppsh use 3d sights?

SethLive! · Post by **SethLive!** » 2007-09-24 00:41

'Xander[nl wrote:;492818']That would require new models for every weapon you'd like to change. Since DICE models cant be edited. (I think)

And that takes a very lot of time.

no I'm just talking about the 2d iron sights, which as far as i know have nothing to do with the 3d model

[R-DEV]Vaiski wrote:Yes its possible.

is it difficult?

hurts · Post by **hurts** » 2007-09-24 00:42

Most likely.

Post by **e-Gor** » 2007-09-24 00:52

Not particularly difficult (just need to create a new blurred rear sight texture), but time consuming and relatively low priority.

Expendable Grunt · Post by **Expendable Grunt** » 2007-09-24 01:26

What's wrong with the M16 sights now? I haven't looked through one so I don't know.